AEG Electrolux CHDL 4150 Spécifications télécharger pdf (Page 10)

Fig. 5

Charcoal filter

 The charcoal filter should only be used if you want to use the hood

in the recirculation function.

 To do this you will need an original charcoal filter (available from

your local Service Force Centre).

 Replacing the charcoal filter Type 150

Note: this filter is already installed on model 570 D-m9.

This filter cannot be cleaned or reused.

As a general rule, the activated charcoal filter should be changed

once every 4 months.

 Cleaning/replacing the charcoal filter Type 150 LONG LIFE

Unlike other charcoal filters, the LONGLIFE charcoal filter can be

cleaned and reactivated. At normal use the filter should be cleaned

every second month (when using the hood 2,5 hours per day, on

avarage). The best way to clean the filter is in the dishwasher. Use

normal detergent and choose the highest temperature (65º C).

Wash the filter separately so that no food parts gets stuck on the

filter and later causes bad odours. To reactivate the charcoal, the

filter should be dried in an oven for 10 minutes with a maximum

temperature of 100ºC.

After approximately three years of use, the charcoal filter should be

replaced with a new, as the odour reduction capacity will be

reduced.

 Fitting

Remove the grease filter.

Fit the charcoal filter on the lamp side, press in both red lugs on the

charcoal filter, and unclip the charcoal filter forwards (towards the

front edge of the appliance).

Refit the grease filter.

 To remove proceed in the reverse order.

 Always specify the hood model code number and serial number

when ordering replacement filters. This information is shown on the

registration plate located on the inside of the unit.

 The charcoal filter can be ordered from your local Service Force

Centre.

Ofrecido por www.electromanuales.com

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 67 68

Pas de commentaire

AEG Electrolux CHDL 4150 Spécifications Page 10