Aeg-Electrolux F78002VI0P Manuel d'utilisateur Page 25

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 32
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 24
WARNING!
To prevent injury or damage, make sure that the appliance is under and adjacent safe struc-
tures. Use the supplied brackets to attach the appliance under the kitchen counter or to the
adjacent units.
Install the appliance under a kitchen counter.
If a repair is necessary, the appliance must be easily accessible for the engineer.
Put the appliance adjacent to a water tap and drain.
For the venting of the appliance only water hoses and mains cable openings are necessary.
The appliance has adjustable feet to allow the adjustment of its height.
Make sure that the water inlet hose, the drain hose and the mains cable are not bent or
squashed, when you insert the appliance.
Adjusting the level of the appliance
A correct adjustment of the level of the appliance allows the door to close and seal correct-
ly.
If the door does not close correctly, loosen or tighten the adjustable feet to level the appli-
ance.
WATER CONNECTION
Water inlet hose
Connect the appliance to a cold water supply.
Connect the inlet hose to a water tap with an external BSP thread spout of 3/4”.
Once connected the inlet hose to the water tap, turn the tap on and check that there are
no leaks.
Inlet water supply
Cold water pressure: 800 kPa max - 50 kPa min.
Water flow rate 10 L / minute min.
If cold water pressure is in excess of 800 kPa, a pressure reducing valve should be used.
Check for leaks.
CAUTION!
Always use new hoses when you connect the appliance to the water mains. Old hoses must
not be used. The water inlet hose must be examined at an interval of twelve months for
deterioration and replaced if necessary.
The water pressure must be in the limits, refer to 'Technical data'.
Make sure that the local water authority gives you the average mains pressure in your area.
Make sure that the water inlet hose is not bent or squashed.
Fit the hose nut correctly to prevent water leaks.
CAUTION!
Do not connect the appliance to new pipes or pipes that have been not used for a long
time. Let the water run for some minutes, then connect the inlet hose.
Water connection
25
Vue de la page 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

Commentaires sur ces manuels

Pas de commentaire