Aeg-Electrolux L52840 Manuel d'utilisateur Page 21

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 32
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 20
Frost precautions
If the machine is installed in a place where the temperature could drop below 0°C, proceed
as follows:
1. close the water tap and unscrew the water inlet hose from the tap;
2. place the end of the emergency emptying hose and that of the inlet hose in a bowl
placed on the floor and let water drain out;
3. screw the water inlet hose back on and reposition the emergency emptying hose after
having put the cap on again.
By doing this, any water remaining in the machine is removed, avoiding ice forming and
consequently damage to the appliance.
When you use the machine again, make sure that the ambient temperature is above 0°C.
Every time you drain the water through the emergency emptying hose you must pour 2
litres of water into the main wash compartment of the detergent drawer and then run the
drain programme. This will activate the ECO Valve device avoiding that part of the deter-
gent remains unused at next washing.
What to do if…
Certain problems are due to lack of simple maintenance or oversights, which can be solved
easily without calling out an engineer. Before contacting your local Service Centre, please
carry out the checks listed below.
During machine operation it is possible that the yellow pilot light of button 5 blinks to
indicate that the machine is not working.
Once the problem has been eliminated, press the button 5 to restart the programme. If
after all checks, the problem persists, contact your local Service Centre.
Problem Possible cause/Solution
The washing machine does not start:
The door has not been closed. (Yellow pilot
light of button 5 blinks)
Close firmly the door.
The plug is not properly inserted in the power
socket.
Insert the plug into the power socket.
There is no power at the socket.
Please check your domestic electrical instal-
lation.
The main fuse has blown.
•Replace the fuse.
The selector dial is not correctly positioned and
the button 5 has not been pressed.
Please turn the selector dial and press the
button 5 again.
The delay start has been selected.
If the laundry are to be washed immediately,
cancel the delay start.
What to do if…
21
Vue de la page 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Commentaires sur ces manuels

Pas de commentaire