LAVAMAT 76855A3User manual Washing Machine
2. If required, pour fabric softener into thecompartment marked (the amountused must not exceed the MAX mark inthe drawer).Close the drawer gently.Se
Select the spin speed, NIGHT CYCLE or RINSE HOLD option (button 3)When the required programme has been selected, your appliance automatically proposes
The relevant symbol will appear on the display.This option is recommended for heavily soiled laundry.STAIN optionSelect this option to treat heavily s
To restart the programme from the point at which it was interrupted, press the button 7again. If you have chosen a delayed start the machine will begi
Opening the door after the programme has startedFirst set the machine to pause by pressing the button 7 .• If the DOOR symbol disappears, the door can
WASHING PROGRAMMESProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Spin SpeedMaximum Fabrics LoadType of LaundryOptionsDetergentCompar
ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Spin SpeedMaximum Fabrics LoadType of LaundryOptionsDetergentCompartmentSYNTHETIC60°-
ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Spin SpeedMaximum Fabrics LoadType of LaundryOptionsDetergentCompartmentDRAINDraining
ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Spin SpeedMaximum Fabrics LoadType of LaundryOptionsDetergentCompartmentSPORT JACKETS
ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Spin SpeedMaximum Fabrics LoadType of LaundryOptionsDetergentCompartmentMIX COLDColdM
Thank you for choosing one of our high-quality products.To ensure optimal and regular performance of your appliance please read thisinstruction manual
Temperatures95° or 90°for normally soiled white cottons and linen (e.g. tea cloths, tow-els, tablecloths, sheets...)60°/50°for normally soiled, colour
Removing stainsStubborn stains may not be removed by just water and detergent. It is therefore advisa-ble to treat them prior to washing.Blood: treat
Degrees of water hardnessWater hardness is classified in so-called “degrees” of hardness. Information on hardnessof the water in your area can be obta
Do not use methylated spirits, solvents or similar products to clean the cabinet.Detergent dispenser drawerThe detergent dispenser drawer should be cl
Door sealCheck from time to time the door seal and ob-jects that could be trapped in the fold.Drain pumpThe pump should be inspected regularly and par
7. When no more water comes out, un-screw the pump cover by turning it an-ti-clockwise and remove the filter. Usepliers, if necessary. Always keep a r
Cleaning the water inlet filtersIf the appliance doesn't fill, it takes a long time to fill with water, the starting buttonblinks yellow or the d
Frost precautionsIf the machine is installed in a place where the temperature could drop below 0°C, pro-ceed as follows:1. close the water tap and uns
Problem Possible cause/SolutionThe washing machine does not start:The door has not been closed. • Close the door firmly.The plug is not properly inser
Problem Possible cause/SolutionThere is water on the floor:Too much detergent or unsuitable detergent(creates too much foam) has been used.• Reduce th
Water-stop device 35Water drainage 35ELECTRICAL CONNECTION 36ENVIRONMENT CONCERNS 37Packaging materials 37Ecological hints 37Subject to ch
Problem Possible cause/SolutionSpinning starts late or the machine doesnot spin:The electronic unbalance detection device hascut in because the laundr
Electrical connectionVoltage - Overall power- FuseInformation on the electrical connection is given on the rating plate,on the inner edge of the appli
1. After removing all the packaging, care-fully lay machine on it’s back to removethe polystyrene base from the bottom.2. Remove the power supply cabl
4. Slide out the relevant plastic spacers.5. Open the porthole, take out the inlethose from the drum and remove thepolystyrene block fitted on the doo
Positioning and levellingInstall the machine on a flat hard floor.Make sure that air circulation around the ma-chine is not impeded by carpets, rugs e
3. Set the hose correctly by loosening thering nut. After positioning the inlet hose,be sure to tighten the ring nut again toprevent leaks.4. Connect
This could be done by tying it to the tapwith a piece of string or attaching it tothe wall.2. In a sink drain pipe branch. Thisbranch must be above th
WARNING!Should the appliance power supply cable need to be replaced, this must be car-ried out by a Service Centre.ENVIRONMENT CONCERNSThe symbol on
38
39
• Under no circumstances should you attempt to repair the machine yourself. Repairscarried out by inexperienced people may cause injury or serious mal
www.aeg-electrolux.com/shop 192988330 -A-332010
• Keep all detergents in a safe place out of children’s reach.• Make sure that children or pets do notclimb into the drum. To prevent children orpets
Detergent dispenser drawer Compartment for detergent used for prewash . The prewash detergent is added atthe beginning of the wash programme. Compartm
2 TEMPERATURE button3 SPIN reduction button4 OPTIONS button5 OK button6 TIME SAVING button7 START/PAUSE button8 DELAY START button9 DisplaySymbols: Ha
– After the programme has started, the time remaining is updated every minute.• Delay start– The selected delay (20 hours max) set by means of the rel
To enable (or disable) this option press simultaneously for about 6 seconds buttons 4 and5 until the Child Lock symbol appears on (or disappears from)
Commentaires sur ces manuels