Aeg-Electrolux 95852G-M Manuel d'utilisateur

95852 GInstruction Booklet Gas HobGBIE

10Before any maintenance or cleaning can be carried out, you mustDISCONNECT the hob from the electricity supply.The hob is best cleaned whilst it is s

11The BurnersThe burner caps and crowns can be removed for cleaning.Wash the burners caps and crowns using hot soapy water, and remove marks witha mil

12Something Not Working?If the hob is not working correctly, please carry out the following checks beforecontacting your local Service Force Centre.

13OVERALL DIMENSIONS Width: 894 mmDepth: 510 mmCUT OUT DIMENSIONS Width: 830 mmDepth: 480 mmThickness: 30 mmSUPPLY CONNECTIONS Gas:R 1/2 inch (1/2 inc

14BURNER RAPID SEMI-RAPIDAUXILIARY TRIPLECROWNPOSITION M AX MIN M A X MIN M A X MIN M A X MIN NOMINAL THERMAL POWER kW 3.0 0.75 2

15Important safety requirementsThis hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations(Current Edition) and th

16InstallationIMPORTANTThis hob must be installed by a competent person to the relevant Gas Standards.Any gas installation must be carried out by a re

17A) End of shaft with nutB) WasherC) ElbowFO 0814FO 0264It is important to install the elbow correctly, with the shoulder on the end of thethread, fi

18Building InBuilding over a cupboard or drawerIf the hob is to be installed above a cupboard or drawer it will be necessary to fit a heatresistant bo

19Building over a kitchen unit with doorProper arrangements must be taken in designing thefurniture unit, in order to avoid any contact with thebottom

2Welcome to the world of ElectroluxThank you for choosing a first class product from Electrolux, which hopefully willprovide you with lots of pleasure

20Fitting the Hob into the WorktopCarry out the building in of the hob asfollows:1. place the seals supplied with thehob on the front edge of the cut

21Electrical connectionsAny electrical work required to install this hob should be carried out by a qualifiedelectrician or competent person, in accor

22Permanent ConnectionIn the case of a permanent connection, it is necessary that you install a doublepole switch between the hob and the electricity

23Fault FindingPreliminary Electrical Systems CheckSTARTIsolate applianceand carry out:A: Earth Continuitycheck. Has inlet fuse blown?Carry out:C: Pol

24A. EARTH CONTINUITY CHECKAppliance must be electrically disconnected - meter set on W (Ohms) x 1scale and adjust zero if necessary.— Test leads from

25Check gas supply atburnerIgnition System / Gas IgnitionYESCheck plug top fuse andreplace if necessaryCheck polarity and earthcontinuity of supply po

26CommissioningWhen the hob has been fully installed it will be necessary to check the minimumflame setting. To do this, follow the procedure below.1)

27Conversion from Natural Gas to LPGIMPORTANTThe replacement/conversion from natural gas to LPG should only beundertaken by a competent person.It is i

28Guarantee/Customer ServiceStandard guarantee conditionsWe, AEG-Electrolux, undertake that if within 12 months of the date of the pur-chase this AEG-

29Service and Spare PartsIn the event of your appliance requiring service, or if you wish to purchase spareparts, please contact your local Service Fo

3ContentsImportant Safety Information ... 4Instructions for the User

30This appliance is guaranteed by Electrolux in each of the countries listed at the back of this usermanual, for the period specified in the appliance

31

35693-3301 03/07 R.0 Subject to change without notice Grafiche MDM - Forlìwww.aeg-electrolux.co.uk

4Important Safety InformationYou MUST read these warnings carefully before installing or using the hob. Ifyou need assistance, contact our Customer Ca

5# Ensure the control knobs are in the ‘OFF’ position when not in use.# When using other electrical appliances, ensure the cable does not come intocon

6Description of the HobINSTALLATIONAny gas installation must be carried out by a registered competent person,and in accordance with existing rules and

7Hob burners control knobs The symbols on the knobs mean that : # there is no gas supply there is maximum gas supply there is minimum gas supplyLight

8Using the hob correctlyTo ensure maximum burner efficiency, it is strongly recommended that you use onlypots and pans with a flat bottom fitting the

9As soon as a liquid starts boiling, turn down the flame so that it willbarely keep the liquid simmering.Use only pans or pots with flat bottom.If you