Aeg-Electrolux T56740 Manuel d'utilisateur télécharger pdf (Page 21)

Installation

Appliance positioning

• It is recommended that, for your convenience, the machine is positioned close to your

washing machine.

• The tumble dryer must be installed in a clean place, where dirt does not build up.

• Air must be able to circulate freely all round the appliance. Do not obstruct the front

ventilation grille or the air intake grilles at the back of the machine.

• To keep vibration and noise to a minimum when the dryer is in use, it should be placed

on a firm, level surface.

• Once in its permanent operating position, check that the dryer is absolutely level with

the aid of a spirit level. If it is not, raise or lower the feet until it is.

• The feet must never be removed. Do not restrict the floor clearance through deeppile

carpets, strips of wood or similar. This might cause heat built-up which would interfere

with the operation of the appliance.

• The hot air emitted by the tumble dryer can reach temperatures of up to 60°C. The

appliance must therefore not be installed on floors which are not resistant to high tem-

peratures.

• When operating the tumble dryer, the room temperature must not be lower than +5°C

and higher than +35°C, as it may affect the performance of the appliance.

• Should the appliance be moved, it must be transported vertically.

• The appliance must not be installed behind the lockable door, a sliding door a door with

a hinge on the opposite side to that of the appliance in such a way that a full opening

of the dryer is restricted.

Removing transport safety packaging

CAUTION!

Before use all parts of the transport packaging must be removed.

1. Open loading door

2. Pull off adhesive strips from inside ma-

chine on top of drum.

3. Remove foil hose and polystyrene pad-

ding from the machine.

Electrical connection

Details on mains voltage, type of current and the fuses required should be taken from the

type plate. The type plate is fitted near the loading aperture (see “Product description”

chapter).

Connect the machine to an earthed socket, in accordance with current wiring reg-

ulations.

Installation

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 51 52

Pas de commentaire

Aeg-Electrolux T56740 Manuel d'utilisateur Page 21