DF 6260Cooker HoodOperating and Installation Instructions
10 Warning• Failure to observe the instructions on cleaning the unit and changingthe filters will cause a fire hazard. You are therefore stronglyrecom
11Something Not WorkingIf your appliance fails to work properly please carry out the followingchecks. Symptom SolutionThe cooker hood Check that: The
12Technical SpecificationsDimensions (in cm):Height 38,7Width 59,8Depth 27,5 (+ front panel)Maximum absorbed power (W): 250Motor (W): 2 x 110Lighting
13InstallationPreparing the wall unit - Extractor version• The hood is supplied as anextractor unit.Before installing the hood, drill ahole in the roo
14Spice rack• If a spice rack is to be incorporated in front of the hood, a minimumdistance of 5 mm must be provided between the front edge of thefume
15• If the cupboard is deeper than 300 mm, cover the gap between thehood and the wall with a finishing strip (special accessory).To install it, procee
16Removing the hood from the wall unitIf, for technical reasons (extraction version/recirculation versionconversion) the extractor hood has to be remo
17Installing the front panel (see also “Special accessories”)• Remove first the rear then the front grease filters.• Remove the internal cover pressin
2ContentsSafety warnings ... 3For the user ...
AEG Hausgeräte GmbHPostfach 1036D-90327 Nürnberghttp://www.aeg.hausgeraete.de© Copyright by AEGLI2VEA Ed. 03/06 From the Electrolux Group.
3 Safety warningsFor the user• The cooker hood is designed to extract unpleasant odours fromthe kitchen, it will not extract steam.• Always cover li
4For the installer• When used as an extractor unit, the hood must be fitted with a150mm diameter duct.• When installing the hood, make sure you respec
5- short and straight outlet ducting- keep bends in outlet ducting to a minimum- never install the ducts with an acute angle, they must always followa
6Description of the Appliance• The cooker hood is designed to extract unpleasant odours fromthe kitchen, it will not extract steam.• The hood is suppl
7Control Panel• The switches are mounted on the upper right side of thevisor (Fig. 1 - E).The numbers and symbols have the following meanings (from le
8Maintenance and Care• The hood must always be disconnected from the electricitysupply before beginning any maintenance work.Cleaning the hood• Clean
9Charcoal filter• The charcoal filter should only be used if you want to use the hood inthe recirculation function.• To do this you will need an origi
Commentaires sur ces manuels