Aeg-Electrolux F65080VI Manuel d'utilisateur télécharger pdf (Page 33)

33Connecting the dishwasher

Dishwashers That Can be Integrated

(see installation template supplied)

Using the installation template supplied, split cupboard doors can be easily in

stalled and firmly fitted.

Connecting the dishwasher

Connecting to the water supply

• The dishwasher can be connected to cold or hot water supplies up to max.

60°C.

• The dishwasher must not be connected to open hot water appliances or in

stantaneous water heaters.

Permitted water pressure

Connecting the inlet hose

1 The water inlet hose must not be kinked, crushed or entangled when it is being

connected.

Connect the threaded hose fitting (ISO 2281:2000) on the water inlet hose to a

tap with an external thread (¾ inch). The inlet hose is fitted with either a plastic

or a metal nut:

– Only tighten the nut hand tight.

Then do a visual check for water tightness. (Make sure that the tap is not drip

ping.)

3 So that access to the tap in the kitchen is not restricted by the use of the dish

washer, we recommend installing an additional tap, or fitting a Tbranch to the

existing tap.

Lowest permitted water pressure:

0,1 MPa ( = 1 bar = 10 N/cm

)

Consult your plumber if the water pressure is

less than 0,1 MPa

Highest permitted water pressure:

1 MPa ( = 10 bar = 100 N/cm

)

If the water pressure is greater than

1 MPa, a pressure reduction valve must be used

(available from your dealer).

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 39 40

Pas de commentaire

Aeg-Electrolux F65080VI Manuel d'utilisateur Page 33