Aeg-Electrolux F88080IM Manuel d'utilisateur télécharger pdf (Page 45)

45Connecting the dishwasher

Connecting the dishwasher

Connecting to the water supply

• The dishwasher can be connected to cold and hot water supplies up to max.

60°C.

• The dishwasher must not be connected to open hot water appliances or in

stantaneous water heaters.

Permitted water pressure

Connecting the inlet hose

1 The water inlet hose must not be kinked, crushed or entangled when it is being

connected.

Connect the threaded hose fitting (ISO 2281:2000) on the water inlet hose to a

tap with an external thread (¾ inch). The inlet hose is fitted with either a plastic

or a metal nut:

– Only tighten the nut hand tight.

Then do a visual check for water tightness. (Make sure that the tap is not drip

ping.)

3 So that access to the tap in the kitchen is not restricted by the use of the dish

washer, we recommend installing an additional tap, or fitting a Tbranch to the

existing tap.

1 WARNING!  Dangerous voltage

(This does apply to dishwashers with safety

valve).

The electrical cable for the safety valve is in

the doublewalled water inlet hose and is

live.

Therefore do not immerse the water inlet

hose or the safety valve in water.

Lowest permitted water pressure:

0,1 MPa ( = 1 bar = 10 N/cm

)

Consult your plumber if the water pressure is

less than 0,1 MPa.

Highest permitted water pressure:

1 MPa ( = 10 bar = 100 N/cm

)

If the water pressure is greater than

1 MPa, a pressure reduction valve must be used

(available from your dealer).

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 51 52

Pas de commentaire

Aeg-Electrolux F88080IM Manuel d'utilisateur Page 45