Aeg-Electrolux B89090-5 Manuel d'utilisateur télécharger pdf (Page 48)

Instructions for the Installer

The instructions given below are

designed specifically for a qualified

installer and should aid him or her to

perform all installation, adjustment,

and maintenance operations with

absolute precision and in compliance

with all current legislation and

regulations. We strongly recommend

that all operations for the installation

of the appliance be carried out by

Qualified Personnel in accordance with

existing rules and regulations.

Electrical connection

Prior to making the electrical connection, make

sure that:

— the protection fuse and the domestic

wiring system are suitable to carry the total

electric load of the oven (see rating plate);

— your domestic wiring system has an

efficient earth connection in compliance with

rules and laws in force;

— the wall socket or the omnipole switch

used for the electrical connection can easily

be reached after the oven is built in.

The appliance is supplied with a connection

cable incorporating a standard plug, suitable for

the total electric load shown on the rating plate.

The plug is to be inserted into a suitable wall

socket. If you require a direct connection to the

electric network (mains), it will be necessary to fit

between the appliance and the mains an

omnipole switch, with a minimum gap between

contacts of 3 mm, suitable for the required load

and in compliance with rules in force. The green

& yellow ground wire must not be interrupted by

the switch and it should be 2-3 cm. longer than

the other cables.

Terminal block

The oven is fitted with an easily accessible

terminal block which is designed to operate

with a single-phase power supply of 230 V.

Letter L - Live terminal

Letter N - Neutral terminal

or E - Earth terminal

The mains cable and plug as supplied are to

be connected to a shockproof socket (230 V~,

50 Hz). The shockproof socket must be installed

in accordance with the regulations.

The following types of mains cable are

suitable, taking the necessary rated cross section

into account: H07 RN-F, H05 RN-F, H05 RR-F,

H05 VV-F, H05 V2V2-F (T90), H05 BB-F.

The connection cable must in any case be

laid out so that at no point does it reach 50°C

(over room temperature).

After the connection has been carried out,

the heating elements must be tested by being

operated for about 3 minutes.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 54 55 56

Commentaires sur ces manuels

Pas de commentaire

Aeg-Electrolux B89090-5 Manuel d'utilisateur Page 48

Commentaires sur ces manuels

Produits connexes et manuels pour Fours Aeg-Electrolux B89090-5