Aeg-Electrolux L14950A Manuel d'utilisateur télécharger pdf (Page 38)

Water-stop device

The inlet hose is provided with a water stop device,

which protects against damage caused by water

leaks in the hose which could develop due to nat-

ural ageing of the hose. This fault is shown by a

red sector in the window «A» . Should this occur,

turn the water tap off and refer to your Service

Centre to replace the hose.

Water drainage

•

The height of drain hose do not have to exceed 100 cm.

• The drain hose may be extended to a maximum of 4 metres. An additional drain hose

and joining piece is available from your local Service Centre.

• The drain hose must not be kinked and must be fastened to prevent it falls down.

The end of the drain hose can be positioned in three ways:

Directly into a drain pipe. Attach the hook to drain hose and hang it in the drain pipe.

Make sure that the drain hose doesn't fall down.

The end of the drain hose must always be venti-

lated, i.e. the inside diameter of the drain pipe

must be larger than the outside diameter of the

drain hose.

Hooked over the edge of a sink using the

plastic hose guide supplied with the machine.

In this case, make sure the end cannot come un-

hooked when the machine is emptying. This could

be done by tying it to the tap with a piece of string

or attaching it to the wall.

MAX 100cm

Installation

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44

Pas de commentaire

Aeg-Electrolux L14950A Manuel d'utilisateur Page 38