Aeg-Electrolux L52840 Manuel d'utilisateur télécharger pdf (Page 12)

Cancelling a programme

Turn the selector dial to to cancel a programme which is running. Now you can select a

new programme.

Altering an option or a running programme

It is possible to change any option before the programme carries it out. Before you make

any change, you must pause the washing machine by pressing the button 5.

Changing a running programme is possible only by resetting it. Turn the programme selec-

tor dial to

and then to the new programme position. Start the new programme by

pressing the 5 button again. The washing water in the tub will not emptied out.

At the end of the programme

The machine stops automatically. The light of button 5 and the light 7.1 go off. The phase

light 7.2 illuminates.

If you have set a programme or an option that ends with water in the tub, the correspond-

ing pilot light remains lit. The phase light 7.2 goes on. The door remains locked. The water

must be emptied out before opening the door. During this time, the drum continues to turn

at regular intervals until water drain.

To empty the water out:

•

turn the programme selector dial to

• select the DRAIN or SPIN programme

• if necessary, reduce the spin speed if needed

• press button 5

• when the programme has finished only the pilot light 7.2 comes on.

Turn the programme selector dial to

position to switch the machine off. Remove the

laundry from the drum and carefully check that the drum is empty.

If you do not intend to carry out another wash, close the water tap. Leave the door open to

prevent the formation of mildew and unpleasant smells.

Stand by: once the programme has finished after a few minutes the energy saving system

is enabled with the pilot lights switched on. By pressing any button the appliance will come

out of the energy saving status.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Pas de commentaire

Aeg-Electrolux L52840 Manuel d'utilisateur Page 12