L 88489 FL2EN WASHING MACHINE USER MANUAL
EThe detergent overdosing symbol comes on at the endof the cycle when the appliance detects too much deter-gent.FYou cannot open the appliance door wh
• The percentage of the detergent quantity.The symbols shows the quantity of deter-gent to use for the laundry in the drum.When you press the Start/Pa
THE STAIN-PREWASHBUTTON 8Press button 8 to add the stain and/or aprewash phase to a programme.Press the button again and again to acti-vate one or two
PROGRAMMESProgrammeTemperatureType of loadMax. weight of loadCycledescrip-tionFunctionsCotton95° - ColdWhite and coloured cottonwith normal soil.max.
ProgrammeTemperatureType of loadMax. weight of loadCycledescrip-tionFunctionsAntiAllergy60°White cotton items.This programme removes mi-cro-organisms
4) The wash and spin phase is soft to prevent the creases of the laundry. The appliance addssome rinses.5) The default phase of the spin speed is rela
WOOLMARK CERTIFICATEThe wool wash of this machine has been testedand approved by The Woolmark Company forthe washing of wool containing garments la-be
BEFORE FIRST USE1.To activate the drain system, put 2 li-tre of water in the main wash com-partment of the detergent dispenser.2.Put a small quantity
Make sure that no laundry stays betweenthe seal and the door. There is a risk ofwater leakage or damage to the laundry.FILLING THE DETERGENT AND ADDIT
Check the position of the flap1.Pull out the detergent dispenser untilit stops.2.Press the lever down to remove thedispenser.3.To use powder detergent
CONTENTS4 SAFETY INFORMATION5 TECHNICAL INFORMATION7 PRODUCT DESCRIPTION7 ACCESSORIES8 CONTROL PANEL13 PROGRAMMES16 CONSUMPTION VALUES17 BEFORE FIRST
Before you press button 4 tostart the appliance, you can cancelor change the set of the delaystart.You cannot set the delay start withthe Steam progra
•In the display comes on.• The indicator of the Start/Pause button4 goes off.• The door lock symbol goes off.•Press button 1 to deactivate the ap-pli
HINTS AND TIPSTHE LAUNDRY LOAD• Divide the laundry in: white, coloured,synthetics, delicates and wool.• Obey the washing instructions that areon the l
Level TypeWater hardness°dH °T.H. mmol/l Clarke2 medium 8-14 16-25 1.6-2.5 10-163 hard 15-21 26-37 2.6-3.7 17-254 very hard > 21 > 37 >3.7 &g
CARE AND CLEANINGWARNING!Disconnect the appliance from the mainssupply before you clean it.DESCALINGThe water we use contains limescale. If itbecomes
DETERGENT DISPENSERTo clean the dispenser:121.Press the lever.2.Pull the dispenser out.3.Remove the top part of the liquid ad-ditive compartment.4.Cle
To clean the drain pump:1.Open the drain pump door.2.Pull the flap out to remove it.3.Put a container below the recess ofthe drain pump to collect the
129.Clean the filter under the water tapand put it back in the pump into thespecial guides.10.Make sure that you tighten correctlythe filter to preven
When you drain the water with the emer-gency drain procedure, you must activateagain the drain system:1.Put 2 litres of water in the main washcompartm
TROUBLESHOOTINGThe start of the appliance does not occuror it stops during operation.First try to find a solution to the problem(refer to the table).
FOR PERFECT RESULTSThank you for choosing this AEG product. We have created it to give youimpeccable performance for many years, with innovative techn
Problem Possible cause Possible solutionThe anti-flood de-vice is on. • Disconnect the appliance.• Close the water tap.• Contact the service centre.T
Problem Possible cause Possible solutionThe appliance fillswith water anddrain immediately.The end of the drainhose is too low.Make sure that the drai
INSTALLATIONSPECIAL ACCESSORIES FORINSTALLATIONFIXING PLATE KIT (405517114)Available from your authorized dealer.If you install the appliance on a pli
5.Open the door. Remove the polystyr-ene piece from the door seal and allthe items from the drum.6.Put one of the polystyrene packagingelements on the
10.Remove the three bolts. Use the keysupplied with the appliance.11.Pull out the plastic spacers.12.Put the plastic caps in the holes. Youcan find th
• The appliance must be level and stable.CAUTION!Do not put cardboard, wood orequivalent materials below theappliance feet to adjust the level.THE INL
Water-stop deviceAThe inlet hose has a water stop device.This device prevents water leaks in thehose because of its natural ageing. Thered sector in t
Without the plastic hose guide.• To a sink spigot.Refer to the illustration. Put the drainhose in the spigot and tighten it with aclip. Make sure that
38www.aeg.com
ENGLISH39
SAFETY INFORMATIONBefore the installation and use, read thismanual carefully:• For your safety and the safety of yourproperty• To help the environmen
www.aeg.com/shop 132924050-A-102012
• Do not install and connect a damagedappliance.• Make sure to remove all packaging andtransport bolts.• Make sure that the mains plug is dis-connecte
Water supply 1) Cold waterMaximum load Cotton 8 kgSpin speed Maximum 1400 rpm1) Connect the water inlet hose to a water tap with a 3/4'' th
PRODUCT DESCRIPTION1 2 3 8956741011121Worktop2Detergent dispenser3Control panel4Door handle5Rating plate6Drain pump7Feet for the appliance level8Water
CONTROL PANEL1 2 3456789101On/Off button 2Programme knob 3Display 4Start Pause button5Delay start button6Time saving button7Extra rinse button8Stai
PROGRAMME KNOB 2Turn this knob to set a programme. Therelated programme indicator comes on.DISPLAY 3A HK JC D E F GBM LIThe display shows:AThe tempera
Commentaires sur ces manuels