Aeg-Electrolux LP5252 Manuel d'utilisateur

LP 5252User manual Washing Machine

Select the DELAY START (Button 6)Before you start the programme, if you wish to delay the start, press the button 6 re-peatedly, to select the desired

must be emptied out before opening the door. During this time, the drum continues to turnat regular intervals until water drain.To empty the water out

Programme - Maximum and Minimum Temperature -Cycle Description - Maximum Spin Speed - MaximumFabrics Load - Type of LaundryOptionsDetergent Com-partme

Programme - Maximum and Minimum Temperature -Cycle Description - Maximum Spin Speed - MaximumFabrics Load - Type of LaundryOptionsDetergent Com-partme

2) If you select the Super Quick option by pressing button 4, we recommend that you reduce the maximum load asindicated. (Red. load = reduced load). F

Detergents and additivesGood washing results also depend on the choice of detergent and use of the correct quan-tities to avoid waste and protect the

After each washLeave the door open for a while. This helps to prevent mould and stagnant smells forminginside the appliance. Keeping the door open aft

Do not clean the drum with acidic descaling agents, scouring agents containing chlorine oriron or steel wool.1. Remove any rust deposits on the drum w

6. Pull out the emergency emptying hose,place it in the container and remove itscap.7. When no more water comes out, un-screw the pump cover by turnin

When the appliance is in use and depending on the programme selected there can be hotwater in the pump.Never remove the pump cover during a wash cycle

Thank you for choosing one of our high-quality products.To ensure optimal and regular performance of your appliance please read thisinstruction manual

7. Screw the hose back to the machine andmake sure the connection is tight.8. Turn on the water tap.Emergency emptying outIf the water is not discharg

WHAT TO DO IF…Certain problems are due to lack of simple maintenance or oversights, which can be solvedeasily without calling out an engineer. Before

Problem Possible cause/SolutionThe machine does not fill:The water tap is closed. (Yellow pilot light ofbutton 5 blinks)• Open the water tap.The inlet

Problem Possible cause/SolutionUnsatisfactory washing results:Too little detergent or unsuitable detergent hasbeen used.• Increase the detergent quant

If you are unable to identify or solve the problem,contact our service centre. Before telephoning,make a note of the model, serial number and pur-chas

The consumption data shown on this chart is to be considered purely indicative, as it mayvary depending on the quantity and type of laundry, on the in

3. Unscrew the three bolts with the keysupplied with the appliance.4. Slide out the relevant plastic spacers.5. Open the porthole and remove the poly-

6. Fill the smaller upper hole and the twolarge ones with the corresponding plas-tic plug caps supplied in the bag con-taining the instruction booklet

1. Connect the hose to a tap with a 3/4”thread. Always use the hose suppliedwith the appliance.Do not use the hose from your previ-ous machine to conn

This could be done by tying it to the tapwith a piece of string or attaching it tothe wall.2. In a sink drain pipe branch. Thisbranch must be above th

OPERATING INSTRUCTIONS SAFETY INFORMATIONRead carefully & keep for future reference.• The safety of Your appliance complies with the industry stan

WARNING!Should the appliance power supply cable need to be replaced, this must be carriedout by a Service Centre.ENVIRONMENT CONCERNSThe symbol on t

31

www.aeg.com/shop 132947741-A-242011

• All packing and transit bolts must be removed before use. Serious damage can occur tothe product and to property if this is not adhered to. See rele

• Make sure that children or pets do not climbinside the drum. To prevent children or petsbecoming trapped inside the drum the ma-chine incorporates a

Detergent dispenser drawer Compartment for prewash phase or stain re-mover.The prewash detergent is added at the beginningof the wash programme.The st

Rinse HoldIndicator pilot lights (7)After having pressed the button 5, the WASHING(WASCHEN - LAVAGE) pilot light (7.1) illuminates.When the pilot ligh

Measure out the detergent and the fabric softenerYour new appliance was designed to reduce water, energy and detergent consumption.1. Pull out the dis

Select the SPIN speed or the RINSE HOLD option (Button 2)When the required programme has been selected, your appliance automatically proposesthe maxim