Aeg-Electrolux L52840 Manuel d'utilisateur télécharger pdf (Page 33)

Water inlet

Do not use the hose from your previous machine to connect to the

water supply.

This appliance must be connected to a cold water supply.

Do not place the inlet hose downwards. Angle

the hose to the left or right depending on the

position of your water tap.

Connect the hose to a tap with a 3/4” thread. Always

use the hose supplied with the appliance.

The inlet hose must not be lengthened. If it is too short

and you do not wish to move the tap, you will have to

purchase a new, longer hose specially designed for this

type of use.

3. Set the hose correctly by loosening the ring nut. After positioning the inlet

hose, be sure to tighten the ring nut again to prevent leaks.

4. Connect the hose to a tap with a 3/4” thread.

Always use the hose supplied with the appliance.

Installation should comply with local water authority

and building regulations requirements. Check the

minimum water pressure required for safe operation

of the appliance in the chapter “Technical Data”.

If you cannot make the cold water connection direct

from the rising mains, you may be able to operate the

appliance from your cold water storage system. There should be a minimum verti-

cal distance of 16.5 feet between the appliance’s inlet and the bottom of the water

storage tank.

Water drainage

The end of the drain hose can be positioned in three

ways:

Hooked over the edge of a sink using the

plastic hose guide supplied with the machine.

In this case, make sure the end cannot come

unhooked when the machine is emptying.

This could be done by tying it to the tap with a piece

of string or attaching it to the wall.

In a sink drain pipe branch. This branch must be above the trap so that the bend

is at least 60 cm above the ground.

Installation

HEC0025

132959980.qxd 19/03/2009 15.58 Pagina 33

1 2 ... 28 29 30 31 32 33 34 35 36

Pas de commentaire

Aeg-Electrolux L52840 Manuel d'utilisateur Page 33