Aeg-Electrolux L52840 Manuel d'utilisateur télécharger pdf (Page 30)

2. The other end of the inlet hose which

connects to the machine can be turned

as showed in the picture.

Do not place the inlet hose down-

wards. Angle the hose to the left or

right depending on the position of

your water tap.

3. Set the hose correctly by loosening the

ring nut. After positioning the inlet

hose, be sure to tighten the ring nut

again to prevent leaks.

The inlet hose must not be lengthened. If it is too short and you do not wish to move the

tap, you will have to purchase a new, longer hose specially designed for this type of use.

Installation should comply with local water authority and building regulations require-

ments. A minimum water pressure of 0.05 MPa is required for safe operation of the appli-

ance.

Before connecting up the machine to new pipework or to pipework that has not been used

for some time, run off a reasonable amount of water to flush out any debris that may have

collected in the pipes.

Water drainage

The end of the drain hose can be positioned in three ways:

1. Hooked over the edge of a sink using the plastic hose guide supplied with the ma-

chine.

In this case, make sure the end cannot come unhooked when the machine is emptying.

This could be done by tying it to the tap

with a piece of string or attaching it to

the wall.

2. In a sink drain pipe branch. This branch

must be above the trap so that the bend

is at least 60 cm above the ground.

3. Directly into a drain pipe at a height

of not less than 60 cm and not more

than 90 cm.

The end of the drain hose must always be

ventilated, i.e. the inside diameter of the

drain pipe must be larger than the outside

diameter of the drain hose.

The drain hose must not be kinked.

30 Installation

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

Pas de commentaire

Aeg-Electrolux L52840 Manuel d'utilisateur Page 30