LAVAMAT 82470 BIEN WASHING MACHINE USER MANUAL
ACOUSTIC SIGNALSThe machine is provided with an acousticdevice, which sounds in the following ca-ses:• at the end of the cycle• in the event of operat
ProgrammeMaximum and Minimum TemperatureType of LaundryMaximum LoadCycle De-scriptionOptions Easy Iron60° - ColdMax. load 1 kgSynthetic fabrics to be
ProgrammeMaximum and Minimum TemperatureType of LaundryMaximum LoadCycle De-scriptionOptions SpinMax. load 7 kgSeparate spin for hand washed cotton ga
ProgrammeMaximum and Minimum TemperatureType of LaundryMaximum LoadCycle De-scriptionOptions ECO Cottons Economy40°Max. load 7 kgFast coloured cotton.
FIRST USE1.To activate the drain system, put 2 li-tre of water in the main wash com-partment of the detergent dispenser.2.Put a small quantity of dete
This is the maximum level for the quantity of liquid additives.Always obey the instructions that you find on the packaging of the deter-gent products.
8. Press the button 4: all the option sym-bols appear on the display.To scroll all the available options, pressthe button 4. The relative symbol appea
SETTING THE DELAY START (BUTTON 9)Before you start the programme, if youwish to delay the start, press the button 9repeatedly, to set the desired dela
signal sounds for some minutes. The sym-bol disappears.If you have chosen a programme or anoption that ends with water in the tub, fol-low the below
WATER HARDNESSIf the water hardness in your area is highor moderate, we recommend that you usea water softener for washing machines. Inareas where the
CONTENTS4 SAFETY INFORMATION5 TECHNICAL INFORMATION7 PRODUCT DESCRIPTION8 CONTROL PANEL10 WASHING PROGRAMMES14 FIRST USE14 DAILY USE18 HELPFUL HINTS A
DETERGENT DISPENSERTo clean the dispenser:MAX121.Press the lever.2.Pull the dispenser out.MAX3.Remove the top part of the liquid ad-ditive compartment
AB3.Place a container close to the pumpto collect any spillage.4.Release the emergency emptyinghose (B), place it in the container andremove its cap c
8.Put the cap back on the emergencyemptying hose and place the latterback in its seat.9.Replace the filter into the pump byinserting it correctly into
45°20°6.Install again the inlet hose. Make surethat the couplings are tight to pre-vent leakages.7.Open the water tap.EMERGENCY EMPTYING OUTIf the wat
Problem Possible cause/SolutionThe appliance does notstart:The door has not been closed. • Close the door firmly.The plug is not properly inserted in
Problem Possible cause/SolutionThere is water on thefloor:You have used too much detergent or unsuitable de-tergent (creates too much foam).• Reduce t
Problem Possible cause/SolutionSpinning starts late orthe machine does notspin:The electronic unbalance detection device has cut inbecause the laundry
2.Remove the cardboard top.3.Remove the polystyrene packagingmaterials.4.Remove the internal film.5.Open the door. Remove the polystyr-ene piece from
127.Remove the polystyrene protectionfrom the bottom.8.Pull up the appliance in vertical posi-tion.9.Remove the power supply cable andthe drain hose f
WARNING!Remove all the packaging and thetransit bolts before you install theappliance.We recommend that you keep thepackaging and the transit bolts fo
FOR PERFECT RESULTSThank you for choosing this AEG product. We have created it to give youimpeccable performance for many years, with innovative techn
• Connect the water inlet hose to thecold water tap with 3/4 thread.CAUTION!Make sure that there are no leaksfrom the couplings.Do not use an extensio
• On the edge of a sink.• Make sure that the plastic guide cannotmove when the appliance drains. At-tach the guide to the water tap or thewall.• To a
BUILDING INOVERVIEW600 mm555 mm596 mm170 mm75 mm100 mm60 mmmin.820 mmmin.560 mm818 mm• This appliance has been designed tobe built into the kitchen fu
12• HingesTo mount the hinges it is necessary todrill two holes (dia. 35 mm, depth12.5-14 mm depending on the depth ofdoor furniture) on the inner sid
Fig. 734www.aeg.com
ENGLISH35
www.aeg.com/shop 132928720-A-032012
SAFETY INFORMATIONBefore the installation and use, read thismanual carefully:• For your safety and the safety of yourproperty• To help the environmen
• Do not install and connect a damagedappliance.• Make sure to remove all packaging andtransport bolts.• Make sure that the mains plug is dis-connecte
Water supply 1) Cold waterMaximum load Cotton 7 kgSpin speed Maximum 1400 rpm1) Connect the water inlet hose to a water tap with a 3/4'' th
PRODUCT DESCRIPTION7 8 9101 234561Detergent dispenser2Control panel3Door handle4Rating plate5Drain pump6Feet for the appliance level7Water drain hose8
CONTROL PANEL1 2 3 4 5 6 7 8 91Programme selector dial2TEMPERATURE button 3SPIN button 4OPTION button 5Ok button6TIME SAVING button 7Display8START/PAU
EDELAY START - symbol.FThe display shows the following information:• Duration of the selected programme– After setting a programme, the duration is
Commentaires sur ces manuels